[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

RE: Resetting the Behringer FCB

Have you tried calibrating the pedals while putting something underneath the pedal in both the toe and heal down position. I used a small flat block of wood, just enough to raise the pedal  at either end so the pedal is prohibited from making its full travel.  this will narrow the pedal’s throw range and might cure your problem. What are you controlling with it, is it the  same behavior no matter what or could it be a calibration issue in your software? I think that these pedals just start to give out after a while, I’ve got a couple of my pedal switches that are starting to feel and act gimpy.  Fortunately they aren’t that expensive.



From: Krispen Hartung [mailto:khartung@cableone.net]
Sent: Monday, June 11, 2007 8:07 PM
To: Loopers-Delight@loopers-delight.com
Subject: Re: Resetting the Behringer FCB


Thanks, Bill. I have a problem with my controller pedal B. For some reason, it doesn't start kicking in  (incrementing values above 0) until it is pressed about 25%. It's a real pain in the ass with my max/msp system. Pedal A is fine. I even calibrated the pedals..no effect. Any clue why this would occur?  You think the pedal is defective?



----- Original Message -----



I don't think it makes any difference for your application, though I believe the original factory setting is for the V-amp. In any case, factory rest for the FCB101 is:

  Press & hold footswitches "1" & "6" for at least 3 seconds during power on. The display will start to count down from 9 to 0. Newer versions also refer to manual. This procedure overwrites all user edited presets and replaces them with the original factory settings.





-----Original Message-----
From: Krispen Hartung [mailto:khartung@cableone.net]
Sent: Sunday, June 10, 2007 10:39 AM
To: Loopers-Delight@loopers-delight.com
Subject: Resetting the Behringer FCB


I need to reset my FCB. Anyone know what different settings you get between

the three types of reset configuration shown in the manual? (page 12) All I

need is program changes and both express pedals activated.


1 + 6 V-AMP family products

1 + 7 BEHRINGER guitar amps

1 + 8 BASS V-AMP product range