Echoplex LED level indicators question. Please Help Me!

[weeksville@comcast.net]

I am still looking for an answer to this question.  I have scoured the mailing list and cannot find any help. The closest post I can find is from Kim in 1998.  Please help me.  I upgraded to Loop IV 1.1 software and now the input led and feedback led indicators are not working properly (I think.)  The feedback led registers much hotter than the input led when recording.   My echoplex is 2003 build so the input R10 and R 30 modification is in there.  I put the Loop III 5.0 chips back in the unit and the described problem still exists.  So I put the Loop IV 1.1 back in.  May main question is this... which led should I use to set my levels?  I can get a good solid green signal on the feedback led without the input led even registering (ie it is dark.)  When the input led is good and green, no yellow/orange, and not even close to red, the feedback led is orange and borders on red.  I am using the same gear I have always used so my input instruments haven't changed. HELP!