[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: airFX level mismatch.
RP Collier wrote:
The signal going in to the AirFx needs to be -10. If the EDP has a
switch to change output to -10 then that works. Otherwise you need
something to change the level to line level, like a DI or line level
shifter.
Or the Output Level control on the EDP.
Assuming that the issue here is that the AirFX runs
at -10dB then all you have to do is
reduce the level from the EDP 'till
the Air FX behaves.
...but from your original post I'm not sure that solves the problem.
Are you saying some patches are much louder than others?
In any case "line Level" hasn't meant -10dB since they did away
with using 5 pin din connectors (in the mid 70's ?).
It's a mystery why some manufacturers use it today, probably
connected to "cheap gear" :-(
andy