[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: OSC and I phones and Whiskers on kittens........
LOL yes of course they should... and of course I tested that over and
over...
In the end I find that they do just that... but only if the "Track Follows
CC" parameter in the LP-1 is set to "Yes."
D'oh !!
Phil (triumphant)
On Aug 4, 2011, at 12:48 AM, andy butler wrote:
> hi Phil,
>
> Here's the answer.
>
> The individual track volumes change the Volume of their respective tracks
> *without* selecting the track.
>
>
>
> andy
>
>
>
>
> Phil Clevenger wrote:
>> Andy, and LD crew,
>> Debugging:
>> I have tried the same track-specific commands this evening, MIDI
>> hard-wired directly into the LP-1 from an FC300 controller.
>> Result is exactly the same: Using any of these - Assign Pedal > Track
>> 'n' Volume / Track 'n' Feedback / Track 'n' Pan - fails to select the
>> designated track.
>> Let's say i am at Track 1, and have set up pedal Controllers #7 and #1
>> to govern Track 8 volume and feedback, respectively.
>> Using the Track 8 Volume-assigned pedal will show in the display that
>> it is attempting to control Vol, but the track is still Track 1, and
>> the numeric readout is static no matter how much I flail on the pedal.
>> Just as with the Missing Link, if I invoke the corresponding Select
>> Track 'n' command first, then the controls work fine - for that track
>> only of course. So I might as well be using the generic Track Volume
>> and Track Feedback and Pan commands, with a Select Track to begin with,
>> it would be the same thing. If I wanted the extra gesture :)
>> So it feels to me like the track-specific Vol/Feedback/Pan commands in
>> the LP-1 are just not working as expected. Unless there is some utterly
>> stupid user error happening here?
>> I am using 1.39...
>> Any thoughts? Anyone else see this behavior?
>> Phil :)
>> On Aug 3, 2011, at 1:20 AM, andy butler wrote:
>>> Strange,
>>> it certainly works here with a regular midi controller.
>>> I've got 24 different CC controllers handling Vol Pan and Fbk
>>> for each track. ...and of course, to the LP-1 it makes no difference
>>> which route
>>> the midi came from.
>>>
>>>
>>> Glad you got it working, might be worth solving the mystery though.
>>>
>>> It doesn't make any sense that you were able to get the LP-1 to learn
>>> the CC values (which would have been
>>> displayed on the front panel) and that following that it wouldn't
>>> respond.
>>>
>>> Logically it's either
>>> 1) extra commands being sent by your controller
>>> 2) LP-1 set up file is corrupt (I doubt it, but if you can save it via
>>> pc you could always send it to me for examination)
>>> 3) some fault in the connection that just happened to produce the
>>> observed result.
>>> 4) you're using an old software version on the LP-1...I've not heard
>>> of that issue though.
>>>
>>> andy
>>>
>>> Phil Clevenger wrote:
>>>> Hey Andy,
>>>> Yes, that's the perplexing thing... I am in fact using track-specific
>>>> calls for each fader, as you suggest... I expected the behavior you
>>>> describe, too... but the LP1 will not respond, at least not to
>>>> TouchOSC on my iPad over wifi via the Missing Link, unless I
>>>> explicitly send a Select Track command first :/
>>>> Phil :)
>