[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: Syncing two EDPS
marcus kirby wrote:
Would I just need a midi through box?
Electribe to EDP1
EDP1 Out to EDP 2
EDP 1 Through to Moog MP201
(assuming you still need the Moog)
I think my issue is that I need them to be on separate midi channels.
Basically, I need one controller to control both edps, and I don.commt
think my behringer or anything else does that.
Put both EDPs on one channel, but use the Source# param to
check them to work in different ranges.
andy
On Jun 15, 2011 9:29 AM, "andy butler" <akbutler@tiscali.co.uk
<mailto:akbutler@tiscali.co.uk>> wrote:
> Can't you just midi sync the EDPs ?
> A splitter after the Electribe?
>
> params
> SYNC = In
> 8th/Cycle = length of bar
>
> OR
>
> the edp looptimes can be shown as slightly different,
> and they'll still be in sync, as the syncing action
> chops the loop slightly.
> I'd guess actual beat length is .505 (or so)
> and the edps should stick to that.
>
>
> andy
>
> marcus kirby wrote:
>> Here's my current setup:
>>
>> Electribe midi out -> Moog MP201 Midi in -> CV Gate on/off to EDP1 and
>> EDP2 Beat Sync.
>>
>> EDP one ranges anywhere from .50 to .51 when trying to catch the beat,
>> which is fine when it's just one EDP. But when two start going
together,
>> I'll have one at .51 and the other at .50, which makes EDP2 slightly
off
>> sync.
>>
>> Is there a better way to sync the two?
>