[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: syncing RC -20xl with drum machine
Hi Mike,
Don't give up, it is possible. I have managed to succesfully time-sync my
old RC-20XL with other equipment, specifically my Soundbite Loop Sampler.
What you need to do, though, is to forget about tapping in/out on the
RC20, which would be very hit and miss, but instead use pre-determined
loop lengths, which can be saved as silent loops in the sample memory.
For instance, I created VERY accurate silent loops of 4,8,12,16 and 24
seconds in length. It took a few hours to get the degree of accuracy I
was after, but it is possible. The 16 second loop stayed acceptably in
sync (with my soundbite sampler set to 60bpm) for over 5 minutes. If it
does start to drift, simply stop the RC20 and re-start at the next
appropriate beat.
Hope this helps,
Stephen
www.myspace.com/sylvianfisher
--- On Mon, 21/9/09, Mike Kilburn <mkilburn@eastlink.ca> wrote:
> From: Mike Kilburn <mkilburn@eastlink.ca>
> Subject: syncing RC -20xl with drum machine
> To: "LOOPERS DELIGHT" <Loopers-Delight@loopers-delight.com>
> Date: Monday, 21 September, 2009, 3:02 PM
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> Hi all:
>
>
>
>
>
> Not sure why I
> keep trying to do
> this – forever optimistic I suppose. Without
> attempting MIDI connect which isn’t possible of course with my
>RC-20x.,
> I’ve
> been finding out once again
> that
> when attempting to have the loop played on guitar remain in
> sync with the drum
> pattern, the RC-20’s loop will eventually
> ‘drift’ off out of time. This in
> spite of initially being dead
> on
> and in sync when I set up the loop phrase in time with the
> drum pattern. And of
> course, with my RC-50 the same would occur I suspect,
> unless as previously
> mentioned by others on list, you allow the RC-50 to run
> thru MIDI to the drum
> machine as master.
>
> Any thoughts or
> ideas on this well-worn
> subject would again be appreciated especially from those
> who have tried this
> particular setup with the RC-20xl and drum machine. I am
> using the Roland DR3
> drum machine.
>
>
>
>
> Cheers,
>
>
> Mike
>
>
>
>
>
>
>
>