[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

Re: EH 2880 notes



Fortunately there's not much traffic on that board, so cutting and
pasting the response doesn't take much effort:

Re: Van Sinn's LD 2880 comments and questions..
« Reply #1 on Today at 3:37pm » 


I made some comments while close reading the manual. Comments?
I'm aware some things may have changed with the firmware mentioned in
another thread.



Notes on Electro Harmonix 2880 looper


Manual pp 10:
Feedback control is partly possible. While overdubbing, previous
contents can be set to fade out with each loop.
No direct way of simply activating a 'loop fade-out' function is
available, but can maybe be emulated using overdup without actually
recording new material.

With the 2880, it's all about the interaction with the physical
controls. THere is a 6 channel mixer right there..!


Quote:

Manual pp 13:
The designated 2880 Foot Controller provides buttons for:
New Loop, Record, Play, Track Select, Reverse, Octave
Most buttons and faders et al.. still needs to be operated before being
possible to use the Foot Controller.


Manual pp 19:
In punch-in mode, hitting Record will immidiately start overwriting a
track at the location where Record is hit. It isn't possible to
activate recording and just punch in replacement material in bits
where appropriate; IOW, 2880 doesn't have an input threshold detection
mechanism. Just be ready and record!


Manual pp 23:
2880 has only a very basic MIDI implementation: Sync, Start/Stop
(recording), and Song Position Pointer. Any mode buttons, mix/control
faders et al.. needs to be manually pressed before using the sparse
MIDI commands.

It's strange not even the full Foot Controller functionality is MIDI 
available.


Not true, the MIDI implementation allows every parameter, including
playback speed to be controlled.

Quote:


When used with an external MIDI Clock Master device not sending
contineous clock, the 2880 will still sync, but may lag behind.


Manual - nowhere:
It's clear the 2880 doesn't store any settings upon power-off, i.e.
any use must be setup after each power-on by operating buttons and
faders.


Conclusion: The 2880 is useful from the desk, on/at a keyboard and such,
or with it's designated Foot Controller, though this will still only
provide limited remote control.

-- 
rgds,
van Sinn


On Nov 16, 2007 2:22 PM, Charles Zwicky <cazwicky@earthlink.net> wrote:
> Hardly fine here..! There is a special section on that web forum
> dedicated to the 2880 and those of us who have written volumes and
> volumes about it on the mailing list are loathe to re-type Mailing
> lists suck...