[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
RE: How to simulate a piano sustain pedal with a midi controller like FCB1010 or FC-300
I will say, the UnO firmware doesn't allow you to change banks while
holding
down a pedal. It puts the FCB into 'transpose' mode, which transposes
incoming note-on messages by a specific amount.
dave eichenberger
www.daveeichenberger.com
> Pedal 1 => midi controle message 64 with value between 64-127 => ON
> Pedal 2 => midi controle message 64 with value between 0-63 => OFF
The FAQ page for the fcb1010_uno group specifically refers to a feature
'CC momentary toggling'. It sounds like this may be what you're looking
for.