[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: New Question EDP FCB - Switches
Thanks. Sounds reasonable. EDP, yes, Repeater, no (doesn't have an
on/off switch)!
David
Todd Pafford wrote:
>In general with all such rack effects and any electronic device, it's
>safer to leave them off, turn the strip on, then turn each unit on.
>That way the units' individual power supplies can buffer as they were
>designed to. Throwing a circuit on allows a potentially destructive
>surge to flow down the line and a good power supply will try to buffer
>the surge when it's turned on/off. As an example, consider the common
>light-bulb. They always blow when switched on or off because there's
>no buffering.
>
>Also, devices nowadays may utilize "soft switches". These aren't your
>usual hardware switch, but instead trigger software to turn the power
>supply on/off. I believe my Line6 Echo Pro uses one of these. In
>this case, it's possible that the on/off switch may do some
>house-keeping tasks before/after turning on/off.
>
>Now, I'm no EE, so take my advice with a bit of salt, but it seems
>like a good idea to me to use the unit's power button. After all,
>they put it there for a reason. :)
>
>Todd
>
>
>On 10/28/05, .David.Auker. <DaVAuk@hevanet.com> wrote:
>
>
>>Another EDP item: upon power-up, sometimes (rarely) mine doesn't. I
>>have my gear all plugged into a power strip. Is it ok to just turn that
>>on, with everything turned "on," or should I be using the switch on the
>>EDP itself? (When EDP doesn't power-up, I turn the switch off and on,
>>and it's ok...)
>>
>>
>
>
>
>
>