[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: RC20 - EDP sync
> did not understand what the sync pulse harms
> if you dont want it for the EDP, press Overdub while in Reset!
I was worried because sometimes after I have loaded the loops into
the EDP, I change the RC-20 to slot 11 with my foot. Slot 11 contains
the kick/crash I use at the end, and switching there changes the rate
of LED flash. But I wouldn't do this until after all the loops are
recorded into the EDP.
It would definitely cause problems if I tried to run "OR"ed synch
outputs from both my RC-20s into the EDP. I'd like to do this if possible
so I can load more drum loops into the second RC-20 and still have synch.
> thats only true if Quant is on and for Loop III
>
> >Similarly it will not stop recording till the next synch
> >pulse after you hit Record again.
>
> thats true for Quant, otherwise it waits until the loop is of a full
> multiple length of the incoming sync timing.
>
> >Does this also apply to
> >NextLoop? I am using the EDP with AutoRecord=On so I can
> >record several loops in series without a pause. It would be
> >cool if the EDP would wait for the next synch pulse after
> >hitting Next before starting the recording of the next loop.
>
> yes it does that, but in this case I think Quant makes sense
Great, thanks. The customer support here is amazing! :) Sorry for
asking about stuff that's in the manual. I looked under "SwitchQuant"
but not "Quant".
Mark Smart
www.marksmart.net