[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: RC20 - EDP sync
See "SwitchQuantize" in the EDP manual.
There are various settings for when the EDP will switch to the next loop.
Doug
----- Original Message -----
From: <mwsmart@insightbb.com>
To: <Loopers-Delight@loopers-delight.com>
Sent: Thursday, September 23, 2004 11:15 AM
Subject: Re: RC20 - EDP sync
>
>
>
> > >----- Original Message -----
> > sounds good, usually 2 color LEDs have three legs of which the center
> > is ground.
> > maybe you get a better signal on the other side of the resistor that
> > feeds the LED
> >
> > probably you find a concrete instruction in the LD archive since I
> > usually try to make such tricks available when I discover them... but
> > this may be the less fun way :-)
>
> I found that note by searching for "RC-20 LED" in the
> archives, thanks. I think if I do this I might get burned
> by the fact that the LED is flashing even when the loop is
> not playing. I would want it to only send synch pulses when
> the loop is playing, requiring an "AND" of the Play LED
> and the flashing LED. Maybe a surface mount TTL chip will
> fit in there someplace.
>
> I have a question about Loop IV..I see in the manual that
> if you have synch = In and you hit Record, the EDP will wait
> till the next synch pulse arrives before it starts recording.
> Similarly it will not stop recording till the next synch
> pulse after you hit Record again. Does this also apply to
> NextLoop? I am using the EDP with AutoRecord=On so I can
> record several loops in series without a pause. It would be
> cool if the EDP would wait for the next synch pulse after
> hitting Next before starting the recording of the next loop.
>
> Mark Smart
> www.marksmart.net
>