[
Date Prev][
Date Next] [
Thread Prev][
Thread Next]
[
Date Index][
Thread Index][
Author Index]
Re: RC20 - EDP sync
>----- Original Message -----
>From: "Mark Smart" <mwsmart@insightbb.com>
>To: <Loopers-Delight@loopers-delight.com>
>Sent: Wednesday, September 22, 2004 8:32 PM
>Subject: Re: RC20 - EDP sync
>
>
>> When you did this, did the EDP respond to both red and green flashes
>or just
>red
>> flashes? If it responds to both, it might be possible to get it to
>respond
>only
>> to the red ones by putting a diode in series with it, right? If
>>this is a two
>> color LED whose color is determined by the direction of the current.
>
>Oh, wait...they are probably controlling the color by grounding one
>side of the
>LED and connecting the other to +V, right? So you could get it to respond
>just
>to red flashes by only hooking the wire to the side of the LED that gets
>+V
>during a red flash. Easy enough.
>
>Just thinking out loud...
sounds good, usually 2 color LEDs have three legs of which the center
is ground.
maybe you get a better signal on the other side of the resistor that
feeds the LED
probably you find a concrete instruction in the LD archive since I
usually try to make such tricks available when I discover them... but
this may be the less fun way :-)
--
---> http://Matthias.Grob.org