[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Date Index][Thread Index][Author Index]

RE: How to match parameters on two EDPs



Claude

I put these commands in my PMC10 after setting up the EDPs with the
appropriate IDs, but am not getting any results. 

Is it possible to put a single sysex command to do this midi channel
changing on the EDP?

I understand you're wariness in helping a non-programmer, but I just
want to do this ONE THING!

Dedicated EDP "power-user" without programming chops...

Thanks

Neil


 
> F0 00 01 30 0B 01 01 11 02 01 7F ch F7 this should change the channel
> where
> ch 1=$00, Ch2=$01, et
> 
> BUT this changes channels to both edps
> 
> if you want to change ch on only the slave you must set it to a
different
> device id manually (check the manual) so that the message only go to
one
> of
> the pair
> 
> 
> F0 00 01 30 0B xx  01 11 02 01 7F ch F7
> 
> xx is device id, id  01=$01,  id 02=$02  etc....
> 
> but frankly you're looking for trouble when asking for complicated
stuff
> without really studying midi and the manual for a while
> IMHO advanced stuff is for advanced users that can debug it
themselves....
> 
> Good luck
> 
> 
> Claude
> 
> 
> 
> 
> 
> > I think if someone would walk us through putting sysex strings into
the
> > PMC that would be the way to do it. I looked at the sysex
documentation
> > in the Loop IV manual, but can't figure out how to change the
channels
> > via sysex. Could one of you programmers spell out the appropriate
> > strings with the correct syntax so we could input this into our midi
> > controllers?
> >
> > Thanks
> >
> >
> > Neil
> >
> > > -----Original Message-----
> > > From: Gary Lehmann [mailto:hqr@cox.net]
> > > Sent: Tuesday, February 03, 2004 3:16 PM
> > > To: Loopers-Delight@loopers-delight.com
> > > Subject: How to match parameters on two EDPs
> > >
> > > How about sysx?  That should work--'course, I haven't done it--but
I
> > think
> > > Claude Voit wrote an editor
> > > http://www.loopers-delight.com/LDarchive/200307/msg00081.html
> > > That should let you do it that way.
> > > Best,
> > > Relay
> >
> >