Re: Minimum Requirements

[Phil Clevenger <phil.clevenger@gmail.com>]

(I guess technically that's not copying into nextLoop, but multiplying...!)

On Aug 21, 2011, at 11:36 PM, Phil Clevenger wrote:

> 
> On Aug 21, 2011, at 10:42 PM, Mark Hamburg wrote:
> 
>> I was always a bit frustrated on the EDP that you could only copy into 
>> another loop if it was empty.
> 
> 
> I've been copying into non-empty loops by setting Quantize = Loop or 
> Cycle, and SwitchQuant = CNF. Then I can press NextLoop, and at my 
> leisure press Multiply. Then regardless of the next loop's content, at 
> the next quantized point it starts to lay in the current loop's cycles 
> until you tell it to stop.
> 
> I'd like that to be easier - as you would too I imagine :D  But it works 
> :)
> 
> Phil :)