i tried again today but it didn't
explain me what do you mean by "ground is just the
to wich ground is connected the capacitor ? to the
ground of the input jack ?
i don't understand what's wrong...
----- Original Message -----
Sent: Tuesday, March 08, 2011 11:58
Subject: Re: Vortex Sync with
Ill be honest to you, it was a very long time since I did it
I built the circuit internally inside my Vortex I disconnected
the A/B channel plug. so now I can just connect a regular lead between EDP and
I take a cable from the input jack for the tap switch and the
morph switch, thru small switches mounted on the front of the Vortex, and back
to the circuit, and capaciter, and out the now defunct A/B socket...
(See the two
little switches in the top right?)
One synchs the tap to the EDP one synchs
I have to say that both dont work at the same time, its one
OR the other, but setting a long morph on one preset and a short morph on the
other is very cool, cos then I morph one way over a bar, and then vortex
jumps back and does it again, rather than the usual slow fade both
GUESSING @ A SOLUTION HERE>>>
But connecting the
ground would be wrong. the ground is just the ground. What you should be doing
is connecting the signal to ground via a capaciter, to smooth out (or is it to
lengthen.. ) the pulse. isnt there a diode in there somewhere...? make sure
that its round the right way... they are always the
On Tue, Mar 8, 2011 at 10:11 PM, boost <firstname.lastname@example.org>
don't know what's wrong.
i connected the ground of both jacks to
the ground connected to the capacitor.
is that ok ?
Message ----- From: "mark francombe" <email@example.com>
March 08, 2011 12:59 AM
Subject: Re: Vortex Sync with Echoplex
Mine works... Plus mine can sync morph switching to the beat
Keep trying it's a great mod.
Sent from my (advertisement
On 8 Mar 2011, at 00:57, boost <firstname.lastname@example.org> wrote:
a question for Vortex and EDP owners:
did one of you tried this
tried but didn't manage to make it