] [Thread Prev
Re: EDP Stereo Looping Setup Dilemma
No, put both edps on the same channel and configure the Source# parameter on the edps so that they each use a different range of note-On.
Is there any way to use my FCB1010 to control two EDP's that are assigned separate midi channels (1 & 7)? I still want to be able to control them independently from my computer, but I'd like to control both of them at the same time using the fcb1010.
The FCB1010 only sends one note value per button - if it sent two this would totally work. I tried CC#'s (it send two) which worked, but I couldn't do any long presses, like to erase the loop or reset all loops - so that's out.
I'm thinking I need one of these in the middle to map all the notes coming in on Channel 1 to Channel 7: http://www.midisolutions.com/prodevp.htm
I hope there is no latency issue.