Re:midi splitter?

["Sjaak" <tcplugin@scarlet.be>]

Hi Michael,
I think this is possible. I believe you an use different midi channels 
with both the PCM-10 and EDP. Possible setup without a midi splitter (= 
midi-thru box):
- assign different midi channels to each EDP, 1 and 2
- connect the midi out of the 1st EDP to the midi-in of the 2nd EDP
- connect the midi out of the PCM-10 to the midi-in of the 1st EDP
- activate midi piping (= midi thru) on the 1st EDP

Use different midi channels per PCM-10 patch to either control EDP 1 or 2.

Sjaak

> Michael Peters wrote:
> I use two EDPs that are not in sync, and I use a PMC-10 to control one of
> them - the other one can only be controlled by pushing the EDP 
>pushbuttons.
> Of course, because the EDPs are not in sync, I don't have to control both
> EDPs at once - I do different things with them so I would first use the
> first EDP, then the other.
>
> It would be nice if I had a tiny box that would simply split the signal 
>from
> the PMC-10, connecting it to both EDPs, but it would have to have some 
>kind
> of manual switch so the midi signals would either go this way or that 
>way.