Low Latency Monitoring for PT

[Edwin Hurwitz <edwin@indra.com>]

>At 8:24 AM -0700 3/14/05, Kris Hartung wrote:
>
>>   Is there any chance that you had the Low
>Latency Monitoring option turned on? If this operates in a different
>fashion, I'd really like to know, because whenever I select a buffer
>size over 128, the latency becomes very noticeable.
>
>Where is that setting? I haven't seen it in my version of ProTools LE.
>What do you have under Setup, Preference, and Processing?


 From the PT Reference Guide:

Low Latency Monitoring
(Digi 002 and Digi 002 Rack Only)
Digi 002 and Digi 002 Rack systems can use the
Low Latency Monitoring option to record with
an extremely small amount of monitoring latency,
to as many tracks as each system supports.
To use Low Latency Monitoring:
1 Record enable audio tracks by clicking their
Record Enable buttons. Only tracks with inputs
set to an audio interface (not a bus) use Low Latency
Monitoring.
2 From the Output Selector, assign each track to
either Output 1 or Output 2. Only tracks assigned
to these outputs use Low Latency Monitoring.
3 Select Operations > Low Latency Monitoring.
When Low Latency Monitoring is enabled, any
plug-ins and sends assigned to record-enabled
tracks (routed to Outputs 1-2) are automatically
bypassed, and must remain bypassed. Also,
these tracks will not register on meters for Master
Faders.




HTH
Edwin
-- 

Edwin Hurwitz
Boulder CO
http://www.indra.com/~edwin
http://www.cafemontalban.com Location Recording Services