Support
Looper's Delight
|
Support |
|
|
When I had my DL-4 I had a lot of problems with the unit not remembering the settings of the expression pedal for the looper - I would even make sure that I plugged in the pedal before powering up the unit. It was very annoying when this would happen live. Never had this problem with the Echo Pro though. :::-----Original Message----- :::From: future perfect [mailto:artists@hazardfactor.com] :::Sent: Tuesday, September 02, 2003 9:46 AM :::To: Loopers-Delight@loopers-delight.com :::Subject: RE: Question about Line6 DL-4 ::: :::Well, not exactly, you can assign the exp pedal to effect pre-delay :::time, level, pre-delay modulation (only on the repeats) or loop/direct :::mix. Or all of them at once. You set the knobs one way with the heel up, :::and it remembers them. Then put the toe down and set the knobs any way :::you want, and it remembers them. Then you can 'morph' between the 2 :::sounds. ::: :::Dave Eichenberger :::http://www.hazardfactor.com ::: ::: :::> :::> It works in Loop Mode but only affects the pre-delay. :::> :::> :::> :::And without an expression pedal, the only way to turn the :::> pre echo on or :::off :::is to manually turn the echo's :::> volume up or down. :::> ::: :::> :::I don't know if the expression pedal works in loop mode. Anyone? :::> ::: :::> :::LeonD :::> ::: :::> ::: ::: :::