Support
Looper's Delight
|
Support |
|
|
Ok I reset the ROM chips and powered back up depressing Parameter. The display reads all 8's, I've also gotten all 6's and I've gotten strange lines. Each time I receive one of these (8's, 6's or lines) I power down and real power up with Parameter held down. What does this mean? kevin ----- Original Message ----- From: "Brother Sean" <info@brothersean.com> To: <Loopers-Delight@loopers-delight.com> Sent: Monday, July 22, 2002 8:21 PM Subject: Re: EDP Problem > I disconnected the EDP from midi, powered up and so far this is what has > happened: > > (Loop 4 zips by three times and then the version # 1.1 shows) x 16 and > counting. I think my EDP is getting sicker... > > kevin > > ----- Original Message ----- > From: "Brother Sean" <info@brothersean.com> > To: <Loopers-Delight@loopers-delight.com> > Sent: Monday, July 22, 2002 8:06 PM > Subject: Re: EDP Problem > > > > I tried that, I isolated it from midi but it still did the same thing. > That > > made me really worried... > > > > thanks for your help Kim! > > kevin > > ----- Original Message ----- > > From: "Kim Flint" <kflint@loopers-delight.com> > > To: <Loopers-Delight@loopers-delight.com> > > Sent: Monday, July 22, 2002 5:14 PM > > Subject: Re: EDP Problem > > > > > > > Does it work if you disconnect it from MIDI? Sounds to me like you might > > > have a midi loop somehow. > > > > > > At 06:00 PM 7/22/2002, Brother Sean wrote: > > > >I have an EDP with Loop IV. I installed the software about a month ago > > and > > > >everything was working fine but just over the weekend I have had >some > > > >troubles. When I intially power up the EDP will cycle through its LOOP > 4 > > > >screen two to three times before allowing me to enter the actually > > looping > > > >screen (for lack of a better term the screen where your loop time > > appears). > > > > > > we usually call that "reset" when you haven't recorded any loop yet. Or > we > > > call it the "play state" or "play mode." > > > > > > >It used to never take that long just one cycle through. > > > > > > I'm not sure if I understood exactly what you are seeing, but >normally > the > > > "Loop 4" zips by on the display 3 times at boot up, then stops and steps > > > off the display, then shows the version, and goes to the reset state. > Are > > > you saying that it is repeating all of this sequence several times? >If > it > > > is repeatedly rebooting itself at power up, there may be some >hardware > > > problem. It could be something simple, like the memory or rom sockets > got > > > dirty or a little corroded. Reseating the roms and the memory might > clear > > > it up. > > > > > > >Also when I press the parameter button in order to modify the settings > it > > > >won't let me cycle through Timing, Keys, Midi and Loops. It usually > gets > > > >stuck bouncing between Timing and Keys (with each press of the > Parameter > > > >button) and will rarely cycle all the way through allowing me to get > back > > to > > > >the "actual loop screen". I usually just half to shut it down and power > > back > > > >up. I have tried resetting the EDP by holding down the Parameters > button > > but > > > >that doesn't help. > > > > > > > >It's really strange all this started happening when I was trying to > send > > > >midi CC commands from my Behringer FCB1010 through my MOTU Midi > > Timepiece > > > >II to my Eclipse to change programs up and down. All of my midi gear is > > > >routed through my Timepiece but it has been setup like this for almost > > half > > > >a year and no problems. Also my EDP is set to listen to notes and is on > > Midi > > > >CH#4 and my Eclipse is on Midi CH#5. Are these errors I'm receiving > just > > a > > > >coincidence or do they have a direct correlation to the CC commands >I > > sent > > > >to my Eclipse. Any ideas? > > > > > > If they are really on different channels it should be ok, but your > problem > > > smells a little like a midi loop to me. see if the EDP works when > > > disconnected from the midi stuff and debug from there. > > > > > > kim > > > > > > > > > > > > >______________________________________________________________________ > > > Kim Flint | Looper's Delight > > > kflint@loopers-delight.com | http://www.loopers-delight.com > > > > > > > > > > > >